- solid state relay
- Circuit Board Solid State Relay
- Single phase solid state relay
- Industrial Solid State Relays
- Three-phase solid state relay
- Three-phase forward and reverse solid state relay
- Rail type three-phase solid state relay
- Industrial grade solid state relay module
- Tension controller
- Intelligent voltage regulation module
- Single and three-phase silicon controlled trigger
- heat sink
- Semiconductor module, rectifier bridge series
- time relay
- Digital display counter
- water level controller
- timer
- switching power supply
- S series switching power supply
- MS series switching power supply
- LRS series switching power supply
- D, T, Q multi-group series switching power supply
- DR rail series switching power supply
- NDR rail series switching power supply
- MDR rail series switching power supply
- HDR rail series switching power supply
- FY rainproof series switching power supply
- FS rainproof series switching power supply
- Foot switch
- Fan water pump controller
Single speed fan controller
product detail
Product overview
This series of single-speed fan controller is a high-performance product specially launched in response to market demand for low-power fans below 22KW. It is mainly used for smoke exhaust, fire control, etc.
Model description
W1:153mm H1:91mm W2:144mm
H2:81mm D: 30mm
Wiring port description
| Terminal number | illustrate | Terminal number | illustrate | |
| 1 | Working power supply AC220V live wire | 9 | Remote control point/on start, off stop | Control in automatic state |
| 2 | Working power supply AC220V neutral line | 10/11 | DC24V fire start/start with power, stop with power loss | |
| 3 | Contactor coil control point | 12/13 | DC24V forced start/start with power, stop with power loss | any status |
| 4 | Manual feedback | 14 | Start/jog signal | Manual/automatic state programmable |
| 5 | Public terminal (passive) | 15 | Stop/jog signal | |
| 6 | automatic feedback | 16 | Forced start and stop | any status |
| 7 | Public signal control terminal | 17 | Fault protection signal point/normally open and normally closed programmable | |
| 8 | Fire damper contact/normally closed | |||
Automatic signal wiring
Fire damper: connected to 7#, 8# (connected to normally closed);
Remote control: connect 7#, 9# (start when connected, stop when disconnected)
Fire center control: connect to 10#, 11# (DC24V has no positive or negative distinction)
Forced start control: connect 12#, 13# (DC24V has no positive or negative distinction);
Passive forced start: connect 7#, 14# (start when connected, stop when disconnected).
Function operation description
Power-off memory saving function
This product has a power-off memory saving function. When the power is turned on again after a power outage, it will default to the state before the power outage. For example: when it is in manual mode, the power is off, and when it is powered on, it is in manual mode.
Fault type selection
In the automatic state, press and hold the "Start" button for more than 5 seconds to switch the fault signal type of terminal 15#, which is divided into normally open type and normally closed type. The factory default is normally open type.
Protection type selection
In the automatic state, press and hold the "Stop" button for more than 5 seconds to change the fault protection type of terminal 15 to the fault alarm type. It only alarms but does not disconnect the output, and switches the fault protection type in sequence.
Wiring schematic diagram
Dimensional drawing
